cyma thompson - too much hop-up

[Rusty Lugnuts]

Hi I tried unsuccessfully to get a picture, no luck. The issue is that even with Bastard .30s i get too much hop up. i have ruled out the barrel being bent. Also the hop up is not broken -when you look down the dial and spin the wheel the rubber protrudes even further. The BAXX's system seems to be very much like a W hop in that it's 2 "fingers" sticking down, side by side inside the barrel to backspin the bb. Even at the minimun setting they stick down quite far.The gun shoots 373 FPS plus or minus 2, with .2s. It's the original hop up and has shot at least 10,000 rounds. I'm not sure how to get the barrel and hop up apart as there is no C clip like m4s have. Has anyone successfully sanded or trimmed this type of hop up and how did you do it, because i imagine that if you don't trim both sides the same... your shooting curve balls. Thanks in advance for your help.

[Styrak]

Yes there is a c-clip. If you Google how to disassemble it you would have found your answer:

http://www.airsoft-barracks.com/foru...akedown-guide/

[Rusty Lugnuts]

Now be nice! i watched all the you tube dissassembly videos and they only covered mechboxes. The first page of your links works but not the second. Plus i value info from our gun doc's over some unknown person

[Rusty Lugnuts]

Aha the link worked on my second try thanks

[Styrak]

[Rusty Lugnuts]

ok so the solution was to swap out the stock "baxx" hop up rubber with a PDI W Hold hop rubber. The mounds aren't as big on the W Hold , She'a a death spittin machine now!

[Styrak]

Yup I was going to say just replace it with a regular G&P or Guarder black rubber.