KWA m93r semi auto not working

[Neurotrauma]

Just got a KWA m93r this morning and by the 2nd mag the semi auto function would only fire full auto. I did some research and it seems this is a common problem, I'm sending it back for now but I'm afraid it will have this issue again later, is there a home-fix for this?

Im surprised this would happen, i thought KWA was known for reliability but I didnt even get 3 mags out of it before it happened...

[Foxer2373]

The sear breaks! I'm suprised it broke that fast but if you consistently shoot on 3rd burst they break and only fires full auto(cause there is no sear to stop it) kwa is rear but because the guns shoot hotter than most parts lke that break easier than they should.

Had my m93r for 3 months of regular gaming and no issues so far but I only use semi or full auto.

[Neurotrauma]

so what happens when it breaks? is there a replacement part. how hard is it to replace a sear im new to GBBs.

I can still shoot 3 rnd burst just not semi...

[coolman703]

Easy Fix!

Lightly pull the trigger on full auto :-P

[zippomb]

I have had the no semi issue for over a year and finally found a fix(thank You Ryan D). All it takes is some cardboard or plastic(credit card) and krazy glue. You could make it more permanent but i would rather the fix wear out rather than another part inside the gun.
1. Lay the gun on it's left side & remove the right grip panel, (two flat head screws)

2. Use an alcohol wipe or rubbing alcohol and a Q-tip to clean the area I'm pointing at with the screwdriver. (this same picture has the fix in place already)

3. Find or buy some superglue..... The thin liquid stuff not the gel kind. (I used the cheap stuff $1)

4. Open the glue package and while you're at it cut away a small strip of the compressed cardboard package backing the same width as the tab I've glued it to.

5. Use a drop of glue and glue the strip to the tab as shown in one of the pics......holding it in place for a good 20 seconds with a small flat head screwdriver. (Please note that in the pictures I'm just illustrating this as I have already got a piece glued in) (To clarify, use only one strip of the super glue package backing)

6. Cut off the excess
cardboard flush with metal tab and give the entire patch a coating of super glue. The thin super glue will wick into the paper/cardboard making it rigid and more wear resistant and also oil resistant.

7. Replace the right grip panel and enjoy!

After a few mags worth of use I would re-coat the patch with super glue as by now it will have worn a small notch into the patch and the extra coat will help seal the deal.
The only change I made to this was to use credit card plastic as I thought it would wear better. So far so good, I love having single shot again.

[itairsoft]

From offical KWA forum, someone posted a resolution regarding the shooting mode unreliability issue. It is not perfect but worth to take a look. It is a simple fix that require users to remove the metal bushing and he also attached a photo to identify the part.

If anyone has suggestion that can improve on the current simple fix, please share your valuable opinion.

Also, the credit card/card board fix is another genius solution to fix the issue. Thank you for sharing !

http://kwausa.com/forums/index.php?showtopic=9270

[Neurotrauma]

resurrecting my own necro thread to tell people that you can fix this problem with this part:

http://www.wiitech.com.hk/product-de...product_id=650

I only installed the small part 61, havent put the other part in yet and my semi is already working again. hurray!