|
|||||||||
|
Home | Forums | Register | Gallery | FAQ | Calendar |
Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
|
Thread Tools |
October 31st, 2010, 23:48 | #1 |
CA90 TR shooting problem
I recently purchased a used CA90 TR from a guy who plays in my area, i knew it wasn't working but i figured i could fix it. I have identified that the cut off lever is broken but that would only cause semi to not function but here is my problem.When i fire the gun BB's just roll out of the barrel, i did a quick test with the mech box out of the gun and when the trigger is pulled the air nozzle goes back and forth but never stops at the same postion once you stop pulling the trigger, i would think that when you stop shooting that it would remain in the closed postion.
Help or insight would be much appreciated. this is my first repair so be gentle. |
|
November 1st, 2010, 06:54 | #2 |
On auto, the nozzle will never stay at the same place.
But it will return to the right spot just before the piston is released. You have a problem with either the hop-up/barrel/rubber or the piston/cylinder/nozzle assembly. Easiest is to check the hop-up first. You just have to remove the upper receiver and then push/twist/pull the hop-up and barrel out of it. Carefully remove the clip and the rubber. If there is even the slightest tear, you have to change it (when air pressure build-up, the tear opens and vents all the air). It is possible that it was bunched and just not seated properly. If that does not fix it, you will have to open the mechbox. By the way, a TM compatible cut-off lever works with the CA90. If you still have issues, check for a gundoc near you or PM me if you don't find anyone local (I am from Montreal) |
|
November 1st, 2010, 19:37 | #3 |
Thanks Kos-Mos i took the barrel out of the hop up unit and it did in fact have a tear at the back so i will be ordering one, can i get any hop up chamber rubber or do i need to get a specific one ?
As for the Cut off lever i will be ordering a prometheus hard cut off lever for TM P90 |
|
November 1st, 2010, 22:36 | #4 |
It uses a regular AEG rubber.
I recommend a guarder clear or Prometheus purple. |
|
November 1st, 2010, 23:23 | #5 |
is this the prometheus one your talking about ?
http://shop.ehobbyasia.com/prometheu...soft-type.html |
|
November 2nd, 2010, 13:19 | #6 |
Yes.
You can also get it "locally" from airsoftparts.ca Prices after shipping are really close, not even enough to be worth it on small orders. |
|
November 2nd, 2010, 19:41 | #7 |
ok thanks for you help, i'll be ordering both
|
|
November 18th, 2010, 23:21 | #8 |
hey kos-mos, i got the pieces, can you tell me what that smaller cylinder is thats comes with the purple air seal ?
|
|
November 21st, 2010, 21:32 | #9 |
That "cylinder" is the hop up nub. It's what the hop up actually pushes against to add pressure to the hop up rubber, thus creating a back spin effect. AFAIK, the CA hopup comes a clear nub installed. You should carefully remove it and install the purple nub and see how it affects your performance.
__________________
It is the mark of an educated mind to be able to entertain a thought without accepting it - Aristotle -Founder of Steel City Hamilton Infantry and Tactics -Certified level 43 Autosniper by Commander Amos |
|
|
Bookmarks |
|
|