Silencer Question

TROOPERUSS · February 27th, 2007, 18:01

Quote:

Originally Posted by ILLusion

No other upgrades are required to upgrade to an M4A1 Carbine length inner barrel (363mm).

So I wouldn't have to change to a non ported head to compensate for the increased volume of air in the barrel, as per Kokanee?

ILLusion · February 27th, 2007, 19:47

Ported/non-ported piston heads have nothing to do with that area of performance...

However, as far as UPGRADES goes, I do highly recommend upgrading to a ported/ventilated piston head with bearings. It greatly improves your shot-to-shot velocity consistency.

I think you might be referring to ported/non-ported CYLINDERS?

Assuming your cylinder is bone stock, the one in the MP5 is the same one used in the M4.

TROOPERUSS · February 27th, 2007, 23:45

Ok, I just measured the silencer I have, turns out I was a little off.
It is 185mm past the end of the inner barrel.
This means I would need about a 414mm barrel, is that going to change anything and cause issues?
I mean aside from the fact that I'm either gonna have to cut down a longer barrel, or live with 40mm of foam & silencer, past the end of the inner barrel.

Home	Forums	Register	Gallery	FAQ	Calendar
Retailers	Community	News/Info	International Retailers	IRC	Today's Posts

British Columbia	Alberta
BCAC	EAR
Op-For	JOC
Northern Arms Airsoft	Skunkworx Airsoft
Airsoft Kelowna	RAAT
Prince George Airsoft	Manitoba
Saskatchewan	MAA
SK Airsoft	Ontario
PDW	Airsoft Ottawa
South Sask Mercs	Snow Dragons
Quebec	1st Ranger Platoon
PQAC	Wolfpack Tactical
1st Pathfinders Regiment	TTAC3
Quebec Airsoft
MTX Airsoft	Atlantic
FAQc	Atlantic Airsoft

February 27th, 2007, 19:47	#17
ILLusion GBB Whisperer Trader rating Join Date: Jun 2002 Location: Toronto	Ported/non-ported piston heads have nothing to do with that area of performance... However, as far as UPGRADES goes, I do highly recommend upgrading to a ported/ventilated piston head with bearings. It greatly improves your shot-to-shot velocity consistency. I think you might be referring to ported/non-ported CYLINDERS? Assuming your cylinder is bone stock, the one in the MP5 is the same one used in the M4. __________________ *Advanced Airsoft Armaments and Enhancements* Quick to the gun, sure of your grip. Quick to the threat, sure of your shot. Diligentia, Vis, Celeritas Accuracy, Power, Speed

February 27th, 2007, 23:45	#18
TROOPERUSS Trader rating Join Date: May 2006 Location: Saskatoon SK	Ok, I just measured the silencer I have, turns out I was a little off. It is 185mm past the end of the inner barrel. This means I would need about a 414mm barrel, is that going to change anything and cause issues? I mean aside from the fact that I'm either gonna have to cut down a longer barrel, or live with 40mm of foam & silencer, past the end of the inner barrel. Last edited by TROOPERUSS; February 28th, 2007 at 15:28..

Silencer Question

Accessories Discussion