|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
July 20th, 2011, 00:04
|
#1 |
|
Hop up reassembly question
Hay I'm reassembling my Echo 1 Mp5 hop up, and was wondering how tight the screws that go into the hop up arm should be? As tight as possible? Or to allow for free rotation? Thanks
|
|
|
|
|
July 20th, 2011, 00:53
|
#2 |
|
I usually do it as tight as possible (you're talking about the bucking right?) But since I use a high fps set-up, I use hard buckings and if it's not tight enough, the air would leak.
|
|
|
|
|
|
July 20th, 2011, 01:47
|
#3 |
|
No I mean putting the actual metal screws into the arm that pivots and adjusts the bucking. I think I got it figured out though thanks.
|
|
|
|
|
|
July 20th, 2011, 11:21
|
#4 |
|
This is actually something that requires a little finesse...
I tighten the screws as tight as I can, but not so tight that they strip out (most of my hop-up housings are made of acrylic), and not so tight that they inhibit the adjustment of the bucking.
__________________
* * * * * * * * * Rob Bye  |
|
|
|
|
July 20th, 2011, 14:49
|
#5 |
|
I tighten up the bottom screw all the way, and left the top one mostly tight so the hop up would adjust but stay in place
|
|
|
|
|
 |
|
||||||
| Bookmarks |
|
|
 |
|
