Airsoft Canada - View Single Post - USR11

Cuddles · April 7th, 2009, 23:32

I used to have the same problem after I got my inner barrel upgrade. The inner barrel was getting pushed back causing the mag to not properly secure. I discovered that the end cap was putting a lot of pressure on the inner barrel (edgi barrels are made slightly longer than the stock barrel), which causes this misalignment. Didn't occur often, but it was an annoyance. I fixed it by putting an o-ring at the tip of the end cap, which gave it about 1-2mm of space and greatly reduced the pressure.

Don't know if this is a valid fix or not and not sure if anyone else has a similar problem, but it works well and does not affect the aesthetic appeal of the rifle.

April 7th, 2009, 23:32	#5
Cuddles Trader rating Join Date: Oct 2008 Location: North Vancouver, BC	I used to have the same problem after I got my inner barrel upgrade. The inner barrel was getting pushed back causing the mag to not properly secure. I discovered that the end cap was putting a lot of pressure on the inner barrel (edgi barrels are made slightly longer than the stock barrel), which causes this misalignment. Didn't occur often, but it was an annoyance. I fixed it by putting an o-ring at the tip of the end cap, which gave it about 1-2mm of space and greatly reduced the pressure. Don't know if this is a valid fix or not and not sure if anyone else has a similar problem, but it works well and does not affect the aesthetic appeal of the rifle.