Ok, so i have another problem with my KSC G19.. When i shoot the gun, it shoots several extremely weak shot, none of which result in the bb leaving the gun. When i wanted to strip the gun to see what was going on i found that the slide would not come off. I checked what was hindering it from sliding off the rail smoothly, and discovered that the hammer was in some sort of "half cocked" position (which should not exists on a Glock 19). After some pocking and pushing (using a thin knife to push the hammer back down), i finally succeeded in removing the slide. Now i tried to cock the hammer manually with the slide off and it worked, however when i pull the trigger it occasionally got stuck in the "half cocked position" again. The hammer doesn't seem to be moving as smoothly as its supposed to. I put some grease in the assembly and hoped this would solve the problem but when i put the slide back on and tried firing, the same thing happened as when the problem first started.
I would hate to have to remove the entire assembly because I've heard that its a b*tch to put back together (although i would use that opportunity to install the improved hammer spring i have lying around).
Now, if you made it though that solid paragraph without leaving, I'd like to hear what you guys have to say about this (if somebody has had this problem before i would love to hear from them).
Hammer in "cocked" position
Unknown position
Hammer in "fired" position
October 20th, 2008, 23:43
