|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
October 16th, 2011, 21:56
|
#16 |
|
ok Compression issue followers - update
I changed the oring to a high quailty after market unit I changed the stock ported cylinder with the Modify non ported I Did a teflon mod to the cylinder head (on the CH Oring) and again once the cylinder head was installed in the cylinder I put a small amount of heavy wt Silicone shock oil on the stock Cylinder head thing... (what is the tube the nozzle slides over called??) anywho i put some oil on it to improve the seal between the Nozzle and said tube. fired in a Modify 100 spring and finished with Doing a Remove & Re-install on the madbull 363mm inner, including the teflon mod on the hopup rubber to barrel point. the aeg is now showing 308 FPS to 324 FPS. Once the UMP nozzle arrives and is installed I expect to see 350 Fps using the Remaining Kit is currently has installed. SV
__________________
A single Light is all one needs to find their way through the darkness, But a single BB is all you need to bring it on! ========== Im not worried about the Bullet that has my Name on it, Im worried about the bullet that says "to whom it may concern" Lt. Alexander Washington -(Red Tails 1944) Ret. |
|
|
|
October 17th, 2011, 14:39
|
#17 |
|
a.k.a. HKpro
|
Just for future reference for anyone seeing as its not posted anywhere on the net, the stock G&G nozzle length is 20.2mm, courtesy of the G&G parts department.
|
|
|
|
|
October 17th, 2011, 15:09
|
#18 |
|
|
hahah FFS 20. 2 hahahah
__________________
A single Light is all one needs to find their way through the darkness, But a single BB is all you need to bring it on! ========== Im not worried about the Bullet that has my Name on it, Im worried about the bullet that says "to whom it may concern" Lt. Alexander Washington -(Red Tails 1944) Ret. |
|
|
|
 |
|
||||||
| Bookmarks |
|
|
 |
|
