Prowin 8mm v2

[Caped_crusadar]

so ive been working on installing my prowin 8mm, and had a few questions.

1) why do you need to cut down the hopup rubber? i get that the hop up unit is overall shorter then it regularly is, but then wouldn't the clip not work either?

2) my cylander is a little loose when everything is tightend down, it walbbles a bit in the back. is this going to be a problem?

3) I almost lost my end cap when it shot across the room, is there a place i could get a replacement one if i do loose it?

4) on the back of the end cap is a slot for the back end of a v3 spring guide, but the one that came with it was a v2, is that just to be able to accommodate a v3 if necessary? or is it meant for one.

[ILLusion]

1) Because otherwise it'd be too long and you wouldn't be able to install the barrel clip.
4) The wide groove is just to allow easier installation of the back cap over the spring guide. Have you tried wrestling the back plate on with an M150 spring installed yet? Yep. I thought you'd appreciate the extra space allowance they give you...

[Caped_crusadar]

Originally Posted by ILLusion

4) The wide groove is just to allow easier installation of the back cap over the spring guide. Have you tried wrestling the back plate on with an M150 spring installed yet? Yep. I thought you'd appreciate the extra space allowance they give you...

no, but i did with a m130, and that made me shoot my endcap and spring cap across the room, XD

[ILLusion]

Now imagine trying to install an end cap on that M130 with just two tiny little divots for the v2 spring guide? GOOD LUCK! lol