|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
February 24th, 2008, 10:36
|
#1 |
|
Vicious MSPaint Wizard
|
Slow leaking G&P 40mm shells, need oring ID
Greetings,
Doing a bit of looking around for another member who has issues with his grenades. http://cgi.ebay.com/G-P-40mm-Airsoft...QQcmdZViewItem Pretty standard slow leak, fills fine, valve is properly lubbed and seated, so I'm guessing the oring(s) is/are to blame. Since my google-fu is a bit slow this morning, I'm leaving this here in case someone can point me towards the info before I find it. |
|
|
|
February 24th, 2008, 11:56
|
#2 |
|
the grenades fill valves will always need to be replaced every now and then.
they cost 1$ dollar if u email G&P or madbull for the fill valves. you can buy directly from them. i've bought over 50 valves from madbull. i'm sure they fit G&P's as well. i would stay away from other sites because they charge 5$, too expensive for consumables.
__________________
|
|
|
|
 |
|
||||||
| Bookmarks |
|
|
 |
|
