KJ Works Beretta Elite (HELP with spring)

[Newtothis]

Ok i just took off the right grip of the gun and there is a little spring thing to push up the trigger bar. it fell off now i dont know what way it goes back on... Any one have any instructions on how it fits back on the gun? Thanks

[takatorikku]

if worst comes to worst, just read the gun manual. when i was installinig my metal slide/barrel kit for my USP, the manual was a god-send. it shows you how to take the gun completely apart and put it back together again.

[stokes]

Its hard to explain but I'll try my best.

The small loop should be facing the left that part should be wrapped around the small whole like indentation on the lower frame... The straight section of that spring... (the opposite to the curve) shot be sitting right under the metal bar that extrudes out of the gun... the other side that has the loop should be facing down. I hope that helps.

[Dracheous]

Stokes is fairly acurate, hopefully its not cause I've done this myself.

But one thing I'd like to add here to make sure that might help clear is that the long tail goes into a small trench that is on the trigger bar. Make sure its in there when you are reassembling the grips on. If it falls out ((and it will)) it will either get bent or just might fall through. Ussually fell through with me, till the one time it got bent. Now its on a long list of other parts for my KJW M9 :P.

[Newtothis]

Thanks ill try it out.. the thing is that my gun did not come with the manual... but i lost the spring it fell off in my room so i'm going to have a fun time looking for it, if worst comes to worst where can i buy another one. Or am i screwed.

[ancorp]

You're screwed, Ill give you $10 for whatever is left of the gun

Cheers,
Alex

[Newtothis]

lol nice try. Damn i just bought it too... and i cant find that stupid spring!

[Newtothis]

FOUND THE SPRING AND PUT IT BACK TOGETHER! THANKS EVERYONE!