KJW M700 Upgrades?

hey i was just wondering what kind of upgrades can i do with a KKW M700 for better performance

[CDN_Stalker]

Just mods, no ugrades really required. Cut a couple coils off the striker spring to make it a bit more consistant, and free float the barrel by removing the aluminum mount that attaches the stock to the outer barrel at the front-most sling stud. That will let the barrel sit as it wants to (mine and others I have worked on, sits a bit to the left, which means that when held straight, the inner barrel has a slight bend to it). Stock, it comes with a 6.05mm inner barrel, so you dont' really need to go around looking for a tightbore. And duster / propane is what you want to use in it, with a bare minimum amount of oil used. Green gas puts oil into the barrel every shot, greasing up your hop up and makeing your shots suck. Oh ya, barrel cleaning with a dry patch every 20 shots really helps keep it at it's best!

k thx ill try that

[Redeemer]

hey while were on the subject, my friend just got one of these, and we were trying to figure how you could get a silencer on there whats the best way.

[CDN_Stalker]

Order a threaded adpator for it from WGC.

[thephenom]

I got a King Arms one on the way along with a silencer. Will make a thread about it when I receive it.

oh i got a question about the aluminum mount...isnt that thing there to keep the barrel straight? so wouldnt it be better to keep it straight the wobbel?

[CDN_Stalker]

If the outer barrel wants to lean to one side (in my case to the left) and the inner barrel is set inside it................... inner barrel gets a slight bend with the outer barrel because the outer barrel wants to sit one way and only for looks the outer barrel is forced straight............ not good.

oh ok then. thanks