|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
July 5th, 2009, 18:33
|
#1 | |
|
CA36 Fire Selector
Want to confirm this before I rip it apart...
On the right-side fire selector for a CA36, after removing the set-screw, is the selector lever just friction fit to the gear on the inside? (like the one on the left side). I pulled on it pretty hard and it didn't budge so I want to confirm this before I reef on it harder. Don't feel like breaking it today.
__________________
 Quote:
|
|
|
|
|
July 6th, 2009, 04:16
|
#2 | |
|
there both attached by little allen screws 2.5mm if my memory is good
__________________
Quote:
|
|
|
|
|
|
July 6th, 2009, 11:33
|
#3 |
|
Yeah, just the lug nuts that usually hold the flash hider to the outer barrel.
__________________
Airsoft It's all fun and games until someone gets hurt...and then it becomes sport! |
|
|
|
|
July 6th, 2009, 19:25
|
#4 | |
|
|
Yea, I know the set-screw is in there, I took it out. That bitch must be on with one hell of a friction fit then.
__________________
Quote:
|
|
|
|
|
|
July 6th, 2009, 23:08
|
#5 |
|
|
Hm, odd. It's always seemed to me that the Selector easily falls off when that screw becomes even slightly loose, even just from gaming.
__________________
Airsoft It's all fun and games until someone gets hurt...and then it becomes sport! |
|
|
|
|
July 7th, 2009, 22:58
|
#6 | |
|
|
The right side switch on mine has never been loose. Seriously, if I didn't know any better I'd swear this thing was glued in.
__________________
Quote:
|
|
|
|
|
 |
|
||||||
| Bookmarks |
| Thread Tools | |
|
|
 |
|
