Extendable Stock problems

freecomfighter · February 18th, 2007, 16:46

So, I have an extendable stock installed on my M15A4. However, the bolt that clips it in place, is not doing its job. I spent most of last night trying to figure out how to make it fit so that it will catch, and its just not happening.....

Its the G&P Extended Battery Buttstock.

Basically, to release the stock theres the clip on the bottom, which is also how it stays in place with a bolt basically. And theres the 4 pieces that are involved in it, The Release leaver, the spring, the nut and bolt. I cannot make it so when the bolt is in there attatched with everything, it will catch on the holes on the underside of the stock.

Any help will be appreciated!

jtf2-phalanx · February 25th, 2007, 01:24

So basically it just slides back and forth without catching? If that's the casem then I think the holes are smaller than the bolt. That was the case for me at one time.

Home	Forums	Register	Gallery	FAQ	Calendar
Retailers	Community	News/Info	International Retailers	IRC	Today's Posts

British Columbia	Alberta
BCAC	EAR
Op-For	JOC
Northern Arms Airsoft	Skunkworx Airsoft
Airsoft Kelowna	RAAT
Prince George Airsoft	Manitoba
Saskatchewan	MAA
SK Airsoft	Ontario
PDW	Airsoft Ottawa
South Sask Mercs	Snow Dragons
Quebec	1st Ranger Platoon
PQAC	Wolfpack Tactical
1st Pathfinders Regiment	TTAC3
Quebec Airsoft
MTX Airsoft	Atlantic
FAQc	Atlantic Airsoft

February 18th, 2007, 16:46	#1
freecomfighter Trader rating Join Date: Jun 2006 Location: Winnipeg	Extendable Stock problems So, I have an extendable stock installed on my M15A4. However, the bolt that clips it in place, is not doing its job. I spent most of last night trying to figure out how to make it fit so that it will catch, and its just not happening..... Its the G&P Extended Battery Buttstock. Basically, to release the stock theres the clip on the bottom, which is also how it stays in place with a bolt basically. And theres the 4 pieces that are involved in it, The Release leaver, the spring, the nut and bolt. I cannot make it so when the bolt is in there attatched with everything, it will catch on the holes on the underside of the stock. Any help will be appreciated! __________________ War does not determine who is right - only who is left. ~Bertrand Russell

February 25th, 2007, 01:24	#2
jtf2-phalanx Trader rating Join Date: Dec 2001 Location: Vancouver, BC	So basically it just slides back and forth without catching? If that's the casem then I think the holes are smaller than the bolt. That was the case for me at one time. __________________ "Any punk can shoot from across the room but it takes a real man to get close enough to stab" "Why cause a huge disturbance when you just wanna kill ONE guy?" - Chris Rock

Extendable Stock problems

Doctor's Corner