|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
October 31st, 2006, 16:58
|
#1 |
|
protective flashlight covers
is there any solutions for taking BB's in the bulbs? i'd like to buy a solution since anything i try to fabricate always ends in disaster.
unless its a easy fabrication answer. anything i can buy for a standard taclight, or even specific sizes. i tried google, ebay, and these forums with no luck. |
|
|
|
|
October 31st, 2006, 17:27
|
#2 |
|
Cut a piece of plexiglass and glue it to the front of the light? You could also glue this to some rubber weatherstripping or other such thing to make a tight removable fit.
|
|
|
|
|
October 31st, 2006, 19:53
|
#3 |
|
The lens in an M3 tac light i had got shot out, so what i did was my buddy had some left over plexiglass about 3mm thick. What i did was i cut out a little square then i used a power sander/grinder to round it into a nice circle. Then once it was a nice circle and fit into the old lens houseing i took some super glue put it around the edges of the lens. Now be careful when u do that cause u dont want any on the plexi itself, just the egdes to hold it in. And it stayed in nicely. I sold shortly there after and the guy who bought it thought it was great.
|
|
|
|
|
November 1st, 2006, 00:28
|
#4 |
|
yeah, thats my problem. making it perfectly round. well i bought some plexy glass today and i got a idea from a guy at rona.
use a door knob hole drill bit, i can get it in smaller sizes so that might work for me. thanks for the help |
|
|
|
|
 |
|
||||||
| Bookmarks |
| Thread Tools | |
|
|
 |
|
