Full Auto on Semi - Metal Body Transfer

[sam0182]

Heya Guys,

I searched through and didn't find much relating direct to this...

I've got a brand new M4 version 2 that I'm tossing a metal body on. Conversion is set, everything looks good yet I'm getting full auto on the semi auto mark.

Connections are good, everything looks just fine...except for the lack of semi-auto.

I've done plenty of these and have yet to have much of a problem...

Suggestions?

Appreciate it

[mcguyver]

It's most likely the position that the selector plate sits at when move the selctor lever. If the selector lever will not move much past semi and semi=full and safety still works, you've got your work cut out for you.

I removed the disc in one install and ground it smooth, removing the teardrop shape and it did the trick.

I've tried Systema mechboxes in G&G metal bodies with this problem and ended up scrapping the body for a C.A. body and no problems. Even the new G&G recall boxes do this in the old G&G bodies.

[Groombug]

Don't forget the spring that moves the cut-off lever and the selector plate.

[sam0182]

Eh, yeah...I'm trying the new AIM metal body that "slides" on...it's so damn tight, even after sanding down what I could, really scrapes the shit out of everything.

Thanks again for the help! I do believe it's the spring.

[sam0182]

You're fucking awesome Groom, right on w/that little Spring. Works just fine now, thanks a lot man.

[sam0182]

And on the AIM, I just had a few samples shipped in. Appreciate it.