Airsoft Canada
http://triggerairsoft.com/shop/

Go Back   Airsoft Canada > Discussion > Airsoft Guns Discussion
Home Forums Register Gallery FAQ Calendar
Retailers Community News/Info International Retailers IRC Today's Posts

Issue with battery/cords? I think

:

Airsoft Guns Discussion

Reply
 
Thread Tools
Old April 1st, 2015, 18:32   #1
Krandon
 
Join Date: Oct 2010
Location: Mississauga, ON
Issue with battery/cords? I think

Hey guys. I'm going to be uploading some photos to show my issues. I brought out my gun today, attached a perfectly recharged battery and....nothing. The gun makes a weird "tick" sound when I pull the trigger but nothing else happens. When I hold down the trigger, the battery, cords attached to the battery, and the connector gets SUPER hot. I seriously have no idea what's up and I'm looking for some help.

The first pic is the gun apart where I think the issue might be.


Second picture is of the connector looking normal.


This picture is where it gets weird. I don't know if this is normal. When I pull the trigger this happens.


My thoughts are either that it has something to do with this or the motor. Please help!
Krandon is offline   Reply With Quote
Old April 1st, 2015, 19:00   #2
Danke
 
Danke's Avatar
 
Join Date: Oct 2007
Location: Danger Zone
That is resistance in action.

Heavy spring and a battery without too much shove?
__________________
Airsoft, where nothing is hurt but feelings.
Danke is offline   Reply With Quote
Old April 1st, 2015, 19:24   #3
waylander
 
Join Date: Aug 2014
Location: Edmonton, Alberta
Was it working ok before? sounds like either too much resistance or a short somewhere. Could be a seized motor since you're not getting anything that happens when you pull the trigger. if the spring was too heavy you'd get something happening not just a click.

While I'm nowhere near a gun doc, could be seized motor, short in the system or seized gears.
waylander is offline   Reply With Quote
Old April 1st, 2015, 19:46   #4
RainyEyes
 
RainyEyes's Avatar
 
Join Date: Sep 2013
Location: Scarbororororough
Sounds like the motor is fried. Take off the pistol grip and carefully pull the trigger while holding the motor with an insulated glove. If you see sparks fly, you've got a burnt motor. If not, check that the motor height is properly adjusted so that it isn't seizing. Do NOT mix the red wire and black wire on the motor.
RainyEyes is offline   Reply With Quote
Old April 2nd, 2015, 10:01   #5
EOD Steve
 
EOD Steve's Avatar
 
Join Date: Jun 2012
Gearbox may be seized, meaning that something might be broken inside.
OR you reversed the red/black on the motor.
__________________

The Steve has spoken.
EOD Steve is offline   Reply With Quote
Old April 2nd, 2015, 10:47   #6
ccyg8774
 
ccyg8774's Avatar
 
Join Date: Jun 2012
Location: Brampton, ON
That is certainly not normal, the red fuse is not the problem, it indicates there is a problem. And I think your fuse probably has too high Amp for your setup because it didn't burnt when it should.

First check if the two motor terminals are pluged in wrong. There may be a red spot somewhere on the motor to indicate the red wire should be on this side. If that is fine, either the motor is shorted or it is stuck by something in the gearbox. A quick way to tell would be: remove the battery, remove the grip cap, unplug the motor terminals.

If you have a multimeter, plug in the battery and take a measurement of the voltage across the two motor terminals when the motor terminals are unpluged and the trigger being pulled.

Then take the motor out. If it visually looks fine, keep it out, plug in the motor terminals, pull the trigger to see if the motor turns without a gearbox. Make sure you don't mix the two terminals.

If the motor turns fine outside and the voltage is normal (about 11.5V to 12V when the battery in picture is fully charged), you have a problem inside the gearbox. Otherwise, you have a problem in the circuit.

Did you bought it new or used?
__________________

Last edited by ccyg8774; April 2nd, 2015 at 10:58..
ccyg8774 is offline   Reply With Quote
Old April 2nd, 2015, 12:06   #7
ThunderCactus
Not Eye Safe, Pretty Boy Maximus on the field take his picture!
 
ThunderCactus's Avatar
 
Join Date: Feb 2007
Most likely, the gearbox ended it's cycle with the piston cocked, and the battery simply doesn't deliver enough power to get the motor to turn it over.
Try taking just one shot in semi with a 7.4v or 11.1v lipo.
If the gearbox really IS jammed, it'll still make that "tick" sound, which indicates there's an issue (but a single trigger pull won't break anything on an 11.1v lipo). If it frees up, it means you need a better battery.

Glass fuses don't necessarily trip instantly. They heat up then fail. If it glows like that, it means there's a dead short (if your motor won't turn, or simply doesn't have enough power to turn, it becomes a dead short), and your battery simply doesn't have enough power to burn the fuse out instantly. You don't get very much amperage from those small NiMH batteries.
ThunderCactus is offline   Reply With Quote
ReplyTop


Go Back   Airsoft Canada > Discussion > Airsoft Guns Discussion

Bookmarks

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Airsoft Canada
http://triggerairsoft.com/shop/

All times are GMT -4. The time now is 00:52.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.