Just picked up a gun.

[lemegacool]

i have a gun that is not containing ANY stock parts

[yuhaoyang]

I just have a gun without any stock internals XD
you should have custom built a gun from scratch then =D, would have saved you the cost of whatever the gun origionally was lol

[lemegacool]

Originally Posted by yuhaoyang

I just have a gun without any stock internals XD
you should have custom built a gun from scratch then =D, would have saved you the cost of whatever the gun origionally was lol

yep built entirely off aftermaket upgrade parts and stainless/custom made screws ! lol

[yuhaoyang]

Ohh, do tell do tell, what parts?

[lemegacool]

full g&p and prometheus! lol costed a freakin fortune but it's worth it...

[yuhaoyang]

I've had a shit experience with G&P, bought a complete mechbox, it was completely lemoney... Now the only G&P parts left in it are the piston/cylinder set, spring guide, trigger, and wires. =(
Yours sounds awesome though lol. You havn't got prometheus gears have you?

[lemegacool]

nope hybrid g&p marui cause the g&p spur gear was crooked and was un-shimmable so i switched it with a marui one... the gearbox almost makes any sound...

[yuhaoyang]

Oh man! you had that problem as well? XD maybe it wasn't just me haha. My sector gear was bent, destroying the bearings =(
Oh well, Modify SMOOTH modular FTW! What spring are you using? I'm interested in knowing how well TM gears hold up against 350+fps, if yours is that high.

[lemegacool]

i got rid of the bearings as soon i got the mechbox... and i use a prometheus ms110 spring so about 380 fps

[yuhaoyang]

I'll be running 2 bearings on the bevel gear for the next 4 days lol.
Heh ok gotta stop the thread jack lmao, half a page of epicness. Anyways, brilliant looking gun, start a seperate thread for custom-builds XD

[Styrak]

Originally Posted by yuhaoyang

I'm interested in knowing how well TM gears hold up against 350+fps, if yours is that high.

I ran a Systema M120 (~390-400 FPS) for two years before my gears gave out, and I also got the gun used.

[lemegacool]

marui gears are freakin tough if they are installed properly! and no worry for the thread jack i think the thread pretty much died at the 3/4 of the first page

[yuhaoyang]

aah sweet. Now only if they will fit in reinforced shells XD

[lemegacool]

ehh they fit in reinforced shell i installed it in a reiforced g&p mechbox without a trouble!

[yuhaoyang]

The bevel and spur gears fit fine, but I couldn't install the sector gear into my CA because the gear teeth hitting the piston rubbed against the pin holding the tigger assembly spring. =( So I put that into my kraken and swapped an XYT gear in, which fitted fine lol. And I just opened my Kraken mechbox up, after probably 5k rds it doesn't have any signs of wear on it... goddamn.
[/pointless dribble]