Madbull Slug Round problem

[sharpshooter17]

I think i may have blown out the bearings. the story is i had a mix up with the co2 charger and put 1400psi in the grenade. the o-rings came out too but were reinstalled. i have taken it apart to this point but cant get the centre post peice to come out. here are some pics. also is the a gun doc who can repair and service all grenades?

[coach]

How did you manage to get 1400psi? What is your source? 12gm cartridge or 20oz paintball tank?

Most I've ever seen is was 900psi but that was with a 20oz tank that cooked in the sun all day. While not impossible, I don't think you managed 1400psi!

[sharpshooter17]

well thats what my gauge said but i could have misread that too it was a 12g co2

[coach]

Originally Posted by sharpshooter17

well thats what my gauge said but i could have misread that too it was a 12g co2

yeah, not possible. max PSI on one of those is in the 800 range which is suitable for that grenade. shouldn't have caused the problem you had. plus the madbull gauge doesn't go that high.

[sharpshooter17]

ok well anyways how do i get that centre part out to reset the bearings.
my v2 madbull co2 charger gauge goes to 1200psi and it was maxed out just checked, but i really dont care about presures i just want to know how to get that part out.

[DarkAngel]

Originally Posted by coachster

yeah, not possible. max PSI on one of those is in the 800 range which is suitable for that grenade. shouldn't have caused the problem you had. plus the madbull gauge doesn't go that high.

Really? im pulling about 800-900 with crossman co2 cartridges.

[coach]

Originally Posted by DarkAngel

Really? im pulling about 800-900 with crossman co2 cartridges.

Yeah but you're not going beyond 900 and definitely not 1200 or 1400

[sharpshooter17]

screw this im just going to send it in not really getting help here