If your metal tooth failed then the rest of the teeth are going to shear. Plastic is not meant to hold loads like that. Typically multi-metal tooth pistons save you in that department.
Get a new (better) piston.
What the heck is that orange thing anyway?
As a tip, the 1-wire method of wiring the MERF is preferred as it makes for less wiring to snake through. There is no performance degradation. You'll run into pinches if you do the 2-wire method, unless you clear the proper path for the wires.
Last edited by Stealth; April 25th, 2013 at 15:39..
|