More tweaking on the OLED case is complete, so back to working on the front. I'm hoping that a 6mm section of glass or plexi will be enough to protect it, I have a scope protector that was only 4mm and survived a couple hits.
Overall length is going to be a little longer than this still and maybe a bit more than I had hoped but I don't really want to go with a battery smaller than 800mah, not sure how long this thing will run.
Ordered some connectors and other misc parts, so this will start to slow down a bit as I'm stuck waiting for things to arrive here, but I should be able to at least start programming a bit sometime next week once the connector breakout cables arrive.
Also, the glass/plexi protector will be held in with some screws from the front so it's easy to replace if damaged over time. I'll likely be using carbon fiber PETG for the printing of this with threaded inserts for this part, and as long as it's not a major pain, the picatinny mounts too.
