|
Anyways, ill post up my results when i get some parts in... i hope im able to fix this stupid problem so i can get my gun back in working order. Here is my to do list:
1. Sand the piston rails on the mechbox.
2. I need to drill a larger hole in the mechbox for the rear pin because it doesn't line up with my receiver..
3. Test fit my safety selector with my new selector plate. I may have to sand the circle part of the selector switch if it pushes the plate too forward or too back causing my plate to break.
4. When all the above is done, im going to check shims again, make sure there is no side to side movement, and break in the gears as advised by azatooth.
|