|
It sounds like compression issue to me to.
The o-rings are the rubber rings around the piston
head that ensure insulation?
If yes then i think that they are all fine.i have to check
again and be sure.I did put my finger in the hole and fire a
few shoots but it was easy and my finger didn't move.
I will try what you suggest and move the piston by hand.
When I sealed the gearbox I didn't grease it and left only
the d-boys grease in there but I try to find if the grease that
was taken off by touch is the cause of the problem.
While firing the piston stack a few times.Is this a greasing issue?
|