|
Milan,
The main issue at this point is that...nothing wonky inside fixes itself with continual usage. If something is off inside...it'll either be iffy or it'll get worse.
There's a lot of good advice here already.
1. Start with a fresh battery...you've got a KA Mod stock 9.6v 1400mah mini. If it's the new one...make sure it has a solid low amp setting full charge.
2. Don't feather the trigger. Regardless of semi or full...you need to pull the trigger all the way back to get the switch assembly block far enough forward to make a solid electrical connection and to get it in a spot where the cut over lever hook can knock it out of position reliably.
3. From safe...turn the selector to full...it should a smooth rotation with no binding. Fire a burst (don't need more than 3-4 shots). Then slowly turn the selector back to semi (be sure not to turn it past semi). Fire 1 full-trigger pull semi shot...how did the trigger pull (smoothness, resistance, any sticky points) compare to the full auto burst? If it felt the same that's good. If it felt different, then something is hanging up the trigger...most likely the safety.
4. Repeat the same thing as 3...but start with semi...then compare to full auto.
Let me know how it goes.
Best of luck,
Tys
|