|
With the blowback housing, I have the same thing going on. Just unscrew it slightly and every once in a while just tighten it a bit more, should be fine.
I had the same problem with the hammer as well. First thing I noticed wiht mine is that the sear doesn't get pushed back enough because the hammer strut is too close. I'm not sure I did anything with that, But I'm gonna recommend to you what Illusion recommended to me.
Take apart the grip, and take out the trigger mechanism. On the back of the bar that pushes the sear back, all you need to do is either glue a flat piece of plastic on the back or put a few layers of tape so that it makes it bigger, and easier to pull the trigger.
Hope this helps.
|