I'm not sure if this is a stupid question, but here's my situation and my question: I had a MosFet from when Kos-Mos was selling them on the boards in my AUG. Used it for half of last season and loved the improvements that the chip provided. This season I unpacked my gun, took it to scrims and as soon as I hooked up the battery the fet heated up and actually melted the solder connecting my wire running to my battery.
I've since tested the fet and it seems to be locked "on". It works, but only in the sense that current will run through it continually (also has no obvious burns, like it's burnt out or anything like that). Another local airsmith seemed to think the problem was that it had no heat-sync.
The temperature control function and other features in these ones will prevent that kind of thing happening, correct?
Also, since my gun is already wired up with a broken "dumb" fet, it should just be a matter of soldering the trigger master in its place, right?
Really stoked on 3-round burst and having a working fet in my gun again.
