Airsoft Canada - View Single Post

Double Tapper · April 21st, 2008, 15:59

I was looking around for M16A2 upper&lower receivers blank,I did realize
this was going to be a pricey build.Are there any good quality M16 stocks
rear.I did a tactical prone position and tweaked the seam,no biggy,little
bit of glue,fixed.When you say the bodys need sanding down inside,how
much are you removing?.

April 21st, 2008, 15:59	#41
Double Tapper Trader rating Join Date: Jul 2006 Location: The land of the over regulated and the banners	I was looking around for M16A2 upper&lower receivers blank,I did realize this was going to be a pricey build.Are there any good quality M16 stocks rear.I did a tactical prone position and tweaked the seam,no biggy,little bit of glue,fixed.When you say the bodys need sanding down inside,how much are you removing?.