Turns out Muffin found a way to circumvent the problem with the outer barrel jamming against the slide. I'll just copy and paste the PM Muffin sent over to me:
Quote:
|
i took it completely apart and the only thing that i could think that was causing this was that chamber under the cut-out of the slide jamming the slide half way. so i took it out, and took it to a grinding wheel and knocked it down just a bit, i did it on all 3 sides so it wouldn't look too stupid, but after knocking it down a bit it cycles perfectly, it empties a full mag and locks at the end of the mag. i know its probably not the best solution, but it works awesome know, so yah i just figured i'd pass that on to you maybe if thats the route you want to go,
|
What I just did for mine instead of going at the blocky ends of the outer barrel that is supposed to be the mock chamber, I took a grinder to the bottom edge and now it works fine. All thats wrong with it now is that the slide catch keeps going up maybe 1/3 times, sometimes after every shot, even though the mag still has rounds in it. Also there is still some friction somewhere causing it to double feed sometimes but some good ol' lube can take care of that.
Anyway, just thought I would post the solution so it can go to the proper section now.