Airsoft Canada - View Single Post

[blackwater_hollow] · April 8th, 2008, 16:22

table... or a few precise blows from a hammer (must have hit it over 5 times just to get it to budge about 1mm)

But alas it is off and on the Metal Body!

But another problem has come to mind. The two springs (refer to the g19 or g17 isometric diagram, it is the two springs labeled #23, or the ones that slide into the nozzle thingy).

The problem happened after emptying out 3 magazines on a target. The frame stopped cycling properly, and would get stuck halfway though its cycle. So I took it apart to see what was trying my patients, and both springs were deformed.

So I replaced them, and layed down some covering fire on a pop can, and same thing happened again. So after another take down, 1 of the new springs were deformed (rather mangled actually).

So I have no idea what is going on! (My g19 has only been upgraded with a metal frame and a heavier blowback spring)

Any ideas would be great!!

April 8th, 2008, 16:22	#6
[blackwater_hollow] Trader rating Join Date: Jun 2006 Location: Calgary	table... or a few precise blows from a hammer (must have hit it over 5 times just to get it to budge about 1mm) But alas it is off and on the Metal Body! But another problem has come to mind. The two springs (refer to the g19 or g17 isometric diagram, it is the two springs labeled #23, or the ones that slide into the nozzle thingy). The problem happened after emptying out 3 magazines on a target. The frame stopped cycling properly, and would get stuck halfway though its cycle. So I took it apart to see what was trying my patients, and both springs were deformed. So I replaced them, and layed down some covering fire on a pop can, and same thing happened again. So after another take down, 1 of the new springs were deformed (rather mangled actually). So I have no idea what is going on! (My g19 has only been upgraded with a metal frame and a heavier blowback spring) Any ideas would be great!!