1) Make and Model
-- Crossman, Airmag P50 (USP .45/9mm mockup)
2) Date Purchased
-- May 2007
3) Cost
-- $100.00
4) New/Used?
-- New
5) Mechanical Problems
-- -- Fracture (then broke off) at the top of where you load bb's into the mag (and where they are fired) (August 2007)
6) Esthetic Problems
-- Fracture (then broke off) at the top of where you load bb's into the mag (and where they are fired) (August 2007)
-- Noticed small C02 leak (November 2007)
-- Screw that holds the slide in fixed postion busted through the plastic slide due to dropping it on hard surface (January 2007), the whole slide assembly came apart but was put back together on the spot without much difficulty, now the slide moves as it would on a real handgun (but serves no purpose).
--Acquired 1 small crack on the back of the slide, 1 small piece of body plastic lost and 1 long but harmless scratch on the slide. Again, all due to it being dropped on hard surface in a firefight. (January 2007)
7) Rounds Fired Between Failures
-- 200 to August 2007
-- 350 from August 2007 to November 2007
-- Rounds fired to date: 600
8) Changes to Internals & Externals
-- Expoxy applied to top of mag to fix fractured piece back in place (August 2007)
-- Painted clear body to flat black using Krylon paint (excellent finish) (August 2007)
--Cut off extended outer barrel piece and grinded off small piece of the lower metal slide guide. To make it look like a real USP .45/9mm
9) Resale Date and Value
-- N/A
10) Comments
- Overall this is an excellent handgun for the price you pay.
- If you get it and start using it PAY CLOSE ATTENTION TO THE TOP OF THE MAG WHERE THE C02 BURSTS ARE LET OUT THE PLASTIC WILL FRACTURE, however once it is reinforced you shouldn't have to deal with it again.
- I have not yet solved the C02 leak yet as I haven't had much chance to use it, think it just needs a new O-ring due to how much I have used it
- Personally I would prefer it over a GBB (purely personal preference), because C02 is easy to get, it shoots harder, the gas lasts longer, and is far more affordable if you don't mind not having blowback action and a non metal body (I wish there was a metal C02 gun out there)
Picture