Airsoft Canada - View Single Post

mcguyver · February 3rd, 2008, 00:50

With the motor in the gun, you should be able to turn the sector gear. It will be a little stiff, but easily done. You'll hear the AR latch (as well as see the release) click positively when this is being done. If you can do this, then likely your shimming is fine.

If you can run the motor outside the gun, and your polarity is correct, then the issue is likely not the motor. But beware, I've had 2 cases, one as recently as this fall, with Turbo 2000 motors being improperly labeled at the terminals, where the red mark for (+) was actually the negative terminal, and the unmarked terminal was the true (+).

February 3rd, 2008, 00:50	#4
mcguyver Trader rating Join Date: Aug 2005 Location: Northern Alberta	With the motor in the gun, you should be able to turn the sector gear. It will be a little stiff, but easily done. You'll hear the AR latch (as well as see the release) click positively when this is being done. If you can do this, then likely your shimming is fine. If you can run the motor outside the gun, and your polarity is correct, then the issue is likely not the motor. But beware, I've had 2 cases, one as recently as this fall, with Turbo 2000 motors being improperly labeled at the terminals, where the red mark for (+) was actually the negative terminal, and the unmarked terminal was the true (+). __________________ Age verifier Northern Alberta Democracy is two wolves and a sheep discussing what's for dinner. Freedom is the wolves limping away while the sheep reloads. Never confuse freedom with democracy.