Airsoft Canada - View Single Post - Getting frusterated....need a troubleshoot

Buds and Suds · September 30th, 2007, 20:36

Im in Penticton BC.
And I held both tappet plates side by side, they are IDENTICAL, I dont know why I was suggested to get a new one cause the new one isnt made any better than the stock one. At least I have a spare now.
Can the nozzle in anyway cause lack of power? I think it may be a compression issue. When I fire it, sometimes every round just causes a dent, then suddenly a round will go right through and dent the other side. Before I took it apart though, the stock spring was putting 2 out of 4 bb's through both sides at 2 inches. Soda can im talking about.

ex-royal = RCR?

September 30th, 2007, 20:36	#18
Buds and Suds Trader rating Join Date: Sep 2007 Location: edmonton	Im in Penticton BC. And I held both tappet plates side by side, they are IDENTICAL, I dont know why I was suggested to get a new one cause the new one isnt made any better than the stock one. At least I have a spare now. Can the nozzle in anyway cause lack of power? I think it may be a compression issue. When I fire it, sometimes every round just causes a dent, then suddenly a round will go right through and dent the other side. Before I took it apart though, the stock spring was putting 2 out of 4 bb's through both sides at 2 inches. Soda can im talking about. ex-royal = RCR? Last edited by Buds and Suds; September 30th, 2007 at 20:38..