|
So far........ took it apart....again... and dropped in the stock spring, no change.
Did the compression test and with the plastic nozzle piece taken off, putting my finger over the metal spout on the cylinder head (not the plastic nozzle) made the piston stop immediatly, even without having to slam it (Piston and cylinder head ruled out). With the plastic nozzle on, I could not bring my piston to a stop no matter how hard I tried. There was some resistance but I could not make it stop and could hear air escaping from the base of it. But since there is nothing to seal it, this must be normal. So I put the M120 spring back in, fired it again, and got 1 shot out of 5 to go through the side of the can at 1-2 inches. ugh.. stress.
Also, the last 2-3 bbs in my mag never load, they just fall out when I release the mag. Any ideas? im thinking of replacing the nozzle and maybe get a new piston head and cylinder head. Just to get everything covered, but dont really want to spend much more $$$
|