[tony123]

Ok so I decided to update my TM VSR-10 G-spec. I put in:

-Laylax Zero Trigger
-150% laylax spring
-barrel spacers
- I know I need a spring guide. It will be ordered next group order.

Now heres the problems.

-When I go to pull the cylinder back its very very hard. In order for me to pull it back I have to rest it on my waste and man handle the thing. I aint no small weakling either.

- It sometimes double feeds. I think this is probly caused by me pulling the bolt back then it goes forward a bit and I pull it back ext.

- Sometimes on the pull back of the bolt the cylinder will just lock back at the end of the pull and in order to get it to go forward again I need to hold the bolt and pull the trigger and it slams forward.

Also when I put the spring in it was bigger than the stock one. Is this normal or did I get a defective spring?

Any help would be greatly appreciated.

Thanks very much in advance for anyone who can help me fix this.