Airsoft Canada - View Single Post

beach_boy · April 19th, 2007, 03:43

Now this is from what I have read, and not what I have experienced first hand as I installed a G&P Crane Stock on an ICS. My problem was not the screw, but the stock stem, which is different than TM's, was too long which caused the tube to not stay put (it moved about an inch back and forth). Seeing that you can't cut it off because you have to screw the bolt for the stock into it, I ended up epoxying it to the stock stem and leaving it more of a permanent mod.

From what I have read, the Prime Crane stock is the only stock that will actually fit the stock stem without much modification. Meaning it'll actually screw onto the stem itself and no need to figure out a new way of attaching it on.

Here's the link I found this info on http://68.113.1.17/jokers/forum/inde...opic,84.0.html

And just to highlight it and make things easier for you:

- According to the air smiths at Guns n Guys in Hong Kong, the Prime Crane Stock will fit and without replacing the stock stem. However, a hole needs to be drilled at the bottom of the stem closest to the body for the battery wiring.

I also found something along the same lines on Arnies, but I can't ever find things again on their...

Hope that helps

April 19th, 2007, 03:43	#3
beach_boy Trader rating Join Date: Jan 2005 Location: Prince George, BC	Now this is from what I have read, and not what I have experienced first hand as I installed a G&P Crane Stock on an ICS. My problem was not the screw, but the stock stem, which is different than TM's, was too long which caused the tube to not stay put (it moved about an inch back and forth). Seeing that you can't cut it off because you have to screw the bolt for the stock into it, I ended up epoxying it to the stock stem and leaving it more of a permanent mod. From what I have read, the Prime Crane stock is the only stock that will actually fit the stock stem without much modification. Meaning it'll actually screw onto the stem itself and no need to figure out a new way of attaching it on. Here's the link I found this info on http://68.113.1.17/jokers/forum/inde...opic,84.0.html And just to highlight it and make things easier for you: - According to the air smiths at Guns n Guys in Hong Kong, the Prime Crane Stock will fit and without replacing the stock stem. However, a hole needs to be drilled at the bottom of the stem closest to the body for the battery wiring. I also found something along the same lines on Arnies, but I can't ever find things again on their... Hope that helps __________________ We'll do it like the Italian Job!