Airsoft Canada - View Single Post - CA SIR short type Carbine installation issue

medhatboy · April 17th, 2007, 06:52

The gun started as a regular M15, before I put the SIR on I installed the short aluminum outer barrel, then the SIR, it took all of a few minutes, except for the fact that you need a special wrench to get the CA outer barrels on/off. The rear folding sight had the same problem as being discussed, didn't have a slot for it, so I marked where the bar would sit and used a fine toothed hack saw, cut a slot on either side of the space needed to the right depth, then filed the middel out. The gun looks a bit different now then when I took the picture, I've since put the RDS in a low scope ring, and changed the pistol grip to a KA G26 grip.

April 17th, 2007, 06:52	#13
medhatboy formerly Swatt Five-Six Trader rating Join Date: Dec 2001 Location: Medicine Hat, Alberta	The gun started as a regular M15, before I put the SIR on I installed the short aluminum outer barrel, then the SIR, it took all of a few minutes, except for the fact that you need a special wrench to get the CA outer barrels on/off. The rear folding sight had the same problem as being discussed, didn't have a slot for it, so I marked where the bar would sit and used a fine toothed hack saw, cut a slot on either side of the space needed to the right depth, then filed the middel out. The gun looks a bit different now then when I took the picture, I've since put the RDS in a low scope ring, and changed the pistol grip to a KA G26 grip. __________________ Medicine Hat Airsoft - Home of the Cypress County Tactical Airsoft Team Last edited by medhatboy; April 17th, 2007 at 06:54..