Quote:
Originally Posted by Eddie
Instead of spending $300 and the time it takes to mill it to work without knowing if it will even work. Find the cheapest/used upper and mod it, then you may know if it will even work.
-Total removal of the rear pin area is necessary because there in no tabs on a real upper. Taking all the steel off that area will mean no tabs to hold the upper down.
It make work but unless you know you could be destroying a very nice piece of hardware.
|
well its a good thing im not buying it then eh? dont worry, i can make it work.
Hes not sure if mark from aasurplus can import yet, but modofication isnt a problem.