Airsoft Canada - View Single Post - adapting a radio connector for DEVGRU headset?

Jerold · March 12th, 2007, 17:07

Thanks.

I can take a photo of it for you, but I can't figure out how to post photos onto this board. I can email you a few digital shots. I also found another modelof motorola mic in one of my boxes, but it isn't the same as the one that I am planning on using to do the mod. Although, I am able to disassemble to handset and you can see the wires connected to the mic's board. This one has a toggle switch on the mic, but it may be of some use .
I can't figure out how to take apart the MX300 mic (NMN6125A) without using a hammer. I can unplug the cable from the handset and it uses a 4-pin connector. If you can direct me to a link in how to post photos, please send it thru, but I'll email you a set of photos.

March 12th, 2007, 17:07	#15
Jerold Trader rating Join Date: Feb 2007	Thanks. I can take a photo of it for you, but I can't figure out how to post photos onto this board. I can email you a few digital shots. I also found another modelof motorola mic in one of my boxes, but it isn't the same as the one that I am planning on using to do the mod. Although, I am able to disassemble to handset and you can see the wires connected to the mic's board. This one has a toggle switch on the mic, but it may be of some use . I can't figure out how to take apart the MX300 mic (NMN6125A) without using a hammer. I can unplug the cable from the handset and it uses a 4-pin connector. If you can direct me to a link in how to post photos, please send it thru, but I'll email you a set of photos.