|
Just a heads up, I successfully modded an M16A2 tappet plate (just says A2 on the bottom) to workin my MP5. There were some differences in the ass-end of it, namely it had a very much shallower half round notch in the middle of the front angle that sits on the sector gear axle, and the front edge of it near the horizontal bar that is about 1mm too far forward compared to the MP5 tappet.
Have put about 200-250 rounds through it since getting it to work properly, is holding up (considering the first one broke on me after less than 50shots........ it was old anyways, guess it's time had come.)
|