Airsoft Canada - View Single Post - Barrel Concern for fellow ICS M4/M16 Users/Armorers

Death March · April 9th, 2006, 12:34

Hey no prob!It's funny cause I had the samething happen,I tryed to loosen my outer barrel to put my S.I.R system on and when I unscewed it the inner barrel came out with it.Needless to say it ripped up my hole Hop-up system.If you look at were the set screws push on you'll notice the metal is a little too thin in it.I was going to try and file it on the inside to give the inner barrel some more room,but I'm worried that after doing that,the set screws will go right into the inner barrel.So I just did't tight'n it as much and put some Loctite 242 (Blue one) on it and it's worked great.

April 9th, 2006, 12:34	#8
Death March Trader rating Join Date: Feb 2006 Location: Manitoba	Hey no prob!It's funny cause I had the samething happen,I tryed to loosen my outer barrel to put my S.I.R system on and when I unscewed it the inner barrel came out with it.Needless to say it ripped up my hole Hop-up system.If you look at were the set screws push on you'll notice the metal is a little too thin in it.I was going to try and file it on the inside to give the inner barrel some more room,but I'm worried that after doing that,the set screws will go right into the inner barrel.So I just did't tight'n it as much and put some Loctite 242 (Blue one) on it and it's worked great.