|
Hehe, you think like me Mysteryfish. Actually, yesterday I took my M24 and M700 in, set up two face targets of Bin Laden, shot prone from the same distance, 2 mags worth of 0.29g BBs from my M700 at one target, got about 15hits on his head, the rest were flyers (and had to tweak the hop up a bit) and shot the other one with what must have been 40 shots from my M24, tweaking the hop up every few shots as well, so a lot of misses, but got roughly 24 hits, some dead center almost on the target. Seems both guns like the SGMs better, fine by me.
So ya, because the mags were cold, the storage hut was warmish, and because I didn't pay attention to keepign my mags warm, the cycling was really sluggish and the power wasn't very impressive. I'll do the same tests in the summer to get better results. At one point I considered the hi-flow valves, but then didn't want to bother, the performance is totally adequate as is, and considering I have 4 mags for two G19s (one still has the stock slide)...........
EDIT: I SHOULD mention that I did not do this to show off my Glock 19 or my "skills", my entire point in this is everyone can use heavier BBs in their GBBs w/propane and much better performance than using 0.20g or even 0.25g BBs. Case in point, the times I claimed I was hitting 55 gallon drums at 120ft and 9" pie tins at 100ft (not every shot, but every couple shots would hit, similar to my shooting the hanging extension cord in my basement 30ft away), was BEFORE I upgraded my G19. All it had then was the metal slide/outer barrel and enhanced recoil spring. Since then I discovered and fixed the inner barrel wobble, added all the other parts I listed above.
|