|
the tm mk23 mags have a built in *feature* of a gas presure release valve. if you use green gas or propane this valve can pop open and vent all your gas.
i have a word and pdf file that has a excelletn directions to fix the problem. BUT, my main rig is down with a blown video card. I hope to have it up and running on the inside of a week. if you want, e-mail me and I'll send you the documents when I can get them off my hard drive.
basics:
- punch out the two outside pins on the bottom of hte mag
- drill out remaining pin on the bottom of mag (5/16" I think size drill bit and drill down about 1/8" to clear the mag wall
- take bottom of mag out
- take out he valve
- sand the valve opening to roughen up the surface
- clean area with alcohol
- use 5 minute epoxy, drop in a bit int eh valve opening, put valve in, put more expoy in same location, put spring back in (becareful when you take bottom of mag out as this spring will jump out and you'll loose it) then put bottom of mag back into the mag body.
- wait 30 minutes
- take bottom of mag back out and clean mag insides really good with alcohol to get rid of dust, dirt, metal flakes from drilling and sanding, etc
- re lube the main seals with silicon oil
- reassemble mag
- never worry about this problem again
btw this is a very very common problem with these mags, so don't worry too much about it.
cheers
|