[Janman]

So I took the plunge and replaced my slide, outter barrel, and recoil spring.

Had a few minor battles with the sights and innards but no big deal there.

Did the Mag mod, as per the instructions..piece of cake.

Cleaned up the slide rail slots abit...slides smooth for the most part.

The problem I am having is that the Slide sticks ALL the way back (goes back a couple or three mm's past the slide release ) and needs to be given a lil tap to spring forward. I tried it with the plastic outter barrel and it does not happen so I'm guessing the prob is with the interface between the barrel and the slide. Seems the outter barrel is getting wedged into the front of the slide.

Having compared the two outter barrels I can see no obvious differences in the geometry and so am at a bit of a loss as to what to do about it.

Anyone have any experience with this or any ideas on how to proceed?

Thanks for your time,

J