[Darklen]

I've done rear wire conversions for these model types in my shop before and cetane is correct with the necessary mods. Spacer plate has to be notched or replaced with a notched type (sling mount or otherwise) and the tube mount also has to be notched. Shorten it as much as you need but remember you may have to shorten the retaining screw as well or it may be too long to fit in the spring guide properly. You'll also have to notch the screw retaining/tightening plate as it should be a full round type. I usually just cut most of the lower half off while leaving the threaded hole intact. It's all pretty easy if you have a Dremel and metal cutting bits. A vise to hold the parts while notching is highly recommended as well.