Quote:
Originally Posted by Drakker
If it happens only the first time it means something happens when you cycle it manually. Are you sure you are pushing the slide as far back as it can go? Its very easy to lock the slide on the hammer when cycling it manually. The recoil spring needs to work a bit to gather enough speed to overcome the hammer. On a perfectly tuned setup this should not happen... But unfortunately this is airsoft. Cheaper pistols do it all the time. Try putting the original TM hammer assembly back in and see if it still happens. Then try the TM BBU and nozzle. Try to find out which upgrade part is causing the problem then focus on that.
|
You are 100% correct on the Speed part. I been doing some testing and trial and error without pulling anything apart and paying attend to the moving parts and I noticed ....... Its the loading nozzle / BBU - when I cock it back slowly I noticed that the Loading nozzle does not snap back immediately with or with out a mag in, but if i cock it fast no issues (if mag is in i need to cock it faster and harder to have no issues)
This explain why it cycles perfectly fine and only happens in the one time on manual cocking as when the loading nozzle does not snap back fast enough the hammer gets caught inside the BBU
question now is
1) do i need to find a way to have the hammer cock further back?
2) or do i need to find a way to have teh loading nozzle snap back faster.
Note - everything is lubed correctly now and i think because of the heavier UAC aluminium loading nozzle and all the aluminium parts now in the loading nozzle the spring does not have the power to snap it back.
Thanks.