Airsoft Canada - View Single Post - Shimming new gears issue

ao_tenshi · July 20th, 2015, 13:10

I am using 7.4v Lipo @25C

So Im still stuck with semi seizing when the piston previously stopped at the backward position. This is not the same as the case where the semi-trigger pull was partial causing a seize. Similarly in another build, where I've done AOE and Sorbo, I had to use a shorter spring to correct a similar symptom.

For this current build, I've done the AOE and added a sorbo pad. Should I shorten (cut a few coils) the spring?

July 20th, 2015, 13:10	#24
ao_tenshi Trader rating Join Date: Apr 2011 Location: Toronto, Ontario	I am using 7.4v Lipo @25C So Im still stuck with semi seizing when the piston previously stopped at the backward position. This is not the same as the case where the semi-trigger pull was partial causing a seize. Similarly in another build, where I've done AOE and Sorbo, I had to use a shorter spring to correct a similar symptom. For this current build, I've done the AOE and added a sorbo pad. Should I shorten (cut a few coils) the spring?