Quote:
Originally Posted by slowbird
Thanks. The knocker looks ok but I might as well replace both of them.
So that peice I posted that is broken is part of the casing that the hammer assembly is housed in. I can get a new one of that?
|
You need a whole new right? or left? hammer housing. If you look for a manual for a KJW or Tm P226 you can find the part number and email KJW directly. For the hammer I would go for a steel shooters design valve knocker. Just keep in mind that the knocker is steel, therefore the hardness is higher than Aluminum Zinc. (Pot-Metal) I could see some considerable wear in a few years, but it is not a big deal.