Airsoft Canada - View Single Post - Nozzle-to-Bucking Seal and Midcaps

lurkingknight · August 19th, 2014, 12:03

5fps variance is very good but a bit concerning if that spring topped out at 425, I'd be a bit worried if it sealed on certain shots you'd shoot over the limit. I'm not familiar with what pdi springs are supposed to be in terms of output.

Did you floss or teflon tape the rubber onto the barrel to get a good seal inside the hop up? a good amount of fps can be lost in blowby if the barrel/rubber assembly is not tight int the hopup.

August 19th, 2014, 12:03	#11
lurkingknight "bb bukakke" KING! Trader rating Join Date: Jul 2011 Location: Ottawa	5fps variance is very good but a bit concerning if that spring topped out at 425, I'd be a bit worried if it sealed on certain shots you'd shoot over the limit. I'm not familiar with what pdi springs are supposed to be in terms of output. Did you floss or teflon tape the rubber onto the barrel to get a good seal inside the hop up? a good amount of fps can be lost in blowby if the barrel/rubber assembly is not tight int the hopup. __________________ I futz with V2s, V3s and V6s. I could be wrong... but probably, most likely not, as far as I know.