[kaiu]

Haha since we are talking about Lonex internals....

I recently bought a Lonex S120 gearbox. Sorbo pads installed by Airsoft Store, re-wired in advanced mode to the Merc 3.2...

So I've got pretty much two problems/issues, not sure if anyone has experienced this, and fixed it... (1 fixed I guess)

1. Lonex Tappet Plate (FIXED by using a modified tappet plate)
A little off length-wise, bb's do not feed due to the nozzle not able to be retracted enough.
- Stealth told me it does not work with some hop-ups (did not work with my Lonex, G&P, KA, and even my transparent DBOYS hopups)
- Modified a Modify Tappet Plate, and that fixed it...

2. BB Not being pushed past Hop-Up Rubber after first shot after assembly.
Second problem is where the BB's enter the Lonex Hopup Unit, however the lonex gearbox somehow is not able to push the bb's past the hopup rubber after the first shot everytime right after I put it back together...
- Using O-Rings to push the hopup unit right against the gearbox to prevent air leaks. (First shot is always very close to 429 FPS (Varies mostly between 428-428.9 FPS).
- Only problem is when I drop a second bb in, it won't shoot the second bb until I remove the upper and put it back again lol... (I'm doing this upside down without a mag in to negate mag feeding problems...)
- BB falls all the way in when I drop one down the hopup chamber, it just won't move past the hopup rubber lips, not sure why T_T

What I'm Using
- G&P Magpul Lower
- G&P VLTOR Upper
- Madbull Outer Barrel 14.5"
- Lonex Hop-Up Unit (Used other hopup units such as KA, G&P, DBOYS, SRC)
- R-hopped Prommy 455mm barrel (Used other non r-hopped barrels to test too, Angry Gun, Madbull, Lonex, Various Brass)
- Merc 3.2 installed advanced mode.
- Very strong magnet ACM neodymium motor (Much stronger than my Lonex A1 motor)
- 7.4v lipo (various, mainly use my Nano-tech 3300 mah 35-70C lipo discharge to test)