[Hectic]

Okay so im going to wire my merf in "advanced mode"
I see there are two options and im wondering if there is a major difference or benifate to one way over the other.
The one way is to connect the two motor wires to one of the tabs on the trigger switch and then one signal wire from the merf to the other contact on the trigger.
The seccond way is to wire the motor right to the battery and then run two signal wires from the merf to the trigger (one to each tab) it says this it the "low resistance wire" setup but im sure it works even with stock wires.
So what are the differences or benifates or does it make no difference? Id assume there should be some difference between i just cant find any explination.